16
|
© Munters AB, 2018
5.5 Installation of rafter suspension unit
Fig.8
Fig.8 shows the tilting bracket that has to be attached to
the rafter. In order to enable the bracket to adapt to
different rafter widths, the extra set of holes on the top side
(centre) of the bracket can be used.
Fig.9
The bracket MUST be secured with the accompanying 6
bolts M10 A2, although the attachment holes are arbitrary.
It is recommended that the tilting bracket be held up
against the rafter and the appropriate holes marked off.
Holes should then be drilled all the way through the rafter.
The tilting bracket should be fitted as shown in Fig.9.
Fig.10
When the tilting bracket has been attached to the rafter, it
is ready to be fitted with the suspension arm.
Fig.11
Fit the suspension arm into the tilting bracket and secure
with the accompanying set of bolts.
