NOTE
Use a leather belt that can adequately
support the weight of the unit, and has a
Images are for reference only. Please refer to
the actual product.
2.2 Unbox the Outdoor Unit
2.3 Taking Out Accessories of
Outdoor Unit
2.4 Pipe Fittings
2.5 Remove the Protect Board
Take the unit out from the packing materials:
Be careful not to damage the unit when you use a
cutting tool to remove the wrapping film.
Remove the four nuts on the wooden back stand.
The schematic after the L-shaped pipe (from
accessories) is properly connected to the unit is
shown below:
The accessories for the unit are stored in two parts.
Documents like the manual are located at the top of
the unit. Accessories like the pipes are located inside
the unit, on top of the compressor. The accessories in
the unit are as follows:
Plastic film should be disposed of properly.
Avoid contact by children. Potential risk:
Asphyxia.
WARNING
Name
Qty.
Outline
Function
Installation manual
Reserved for
maintenance
To connect piping
(For 10-18HP)
L-shaped pipe
connection
Erp information
To clean pipes
To connect gas
and liquid pipes
Tie wrap
Screw pack
90° socket elbow
Sealing cover
Build-out resistor
Wrench
1
1
2
1
1
8
3
2
1
To improve
communication
stability
To remove the
side plate
screws
8-12HP
58
55
57
63
62
Auto Gauge point
Low pressure pipe
High pressure pipe
Liquid pipe
14-18HP
HP
8
SIZE
19.1
15.9
9.52
10
12
14
16
18
22.2
19.1
9.52
28.6
19.1
12.7
28.6
22.2
12.7
28.6
22.2
12.7
28.6
22.2
15.9
Unit: mm
Condenser
protect board
76
69
60
Auto Gauge point
Low pressure pipe
High pressure pipe
Liquid pipe
62
42
For some models,there are protecting boards placed
around the condenser. Please remove the protecting
boards when installing the unit, otherwise the capacity
of the outdoor unit will be affected.
Owner’s manual
and
4
