Multitech MultiVOIP MVPGK1 Gatekeepers, Hardware User'S Manual

Page: 17 / 87

MultiVOIP Gatekeeper User Guide
17
Chapter 2 - Installation & Setup
Powering Up
Note: This is pluggable equipment; the socket outlet must be installed near the equipment and must
be easily accessible.
When connecting the equipment to the power-supply circuit, be sure to check equipment nameplate
ratings to avoid overloading circuits. Overloaded circuits may cause damage to over-current protection
devices and to power-supply wiring.
Make sure that the voltage selector on the power supply is set to the proper voltage prior to connecting
this equipment to the main power. If the voltage selector needs to be changed, an ordinary pencil can
be used to change the switch to the position which best correlates with the known input voltage. If the
voltage selector is in the "115" position, input voltages from 100-120VAC may be applied to the
equipment. If the voltage selector is in the "230" position, input voltages from 200-240 VAC may be
applied to the equipment.
Connect the power cord supplied with the CommPlete 4000 to the power cord connector on the back of
the cabinet and to an AC outlet. Press the power switch on the front of the cabinet to the ON position.
The power switch contains an LED which should light when power is applied.
Power Supply
120
Voltage Selector
Power Cord
Input
Monitor Power
Outlet
120
100M LINK ACT
Fig. 2-5. Power Supply Connectors