Multitech MultiConnect MTPCIE-BW, Developer'S Manual

Page: 85 / 88

BLUETOOTH DEVELOPER INFORMATION
MultiConnect
®
PCIe MTPCIE-H5/MTPCIE-BW Developer Guide 85
[ 126.376017] usb 7-
1: new full speed USB device using uhci_hcd and address 3
[ 126.532263] usb 7-1: configuration #1 chosen from 1 choice
[ 126.582980] cdc_acm 7-
1:1.0: This device cannot do calls on its own. It is not a modem.
[ 126.583024] cdc_acm 7-1:1.0: ttyACM0: USB ACM device
[ 126.590282] cdc_acm 7-
1:1.2: This device cannot do calls on its own. It is not a modem.
[ 126.590322] cdc_acm 7-1:1.2: ttyACM1: USB ACM device
[ 126.592170] cdc_acm 7-
1:1.4: This device cannot do calls on its own. It is not a modem.
[ 126.592215] cdc_acm 7-1:1.4: ttyACM2: USB ACM device
[ 126.595064] cdc_acm 7-
1:1.6: This device cannot do calls on its own. It is not a modem.
[ 126.595115] cdc_acm 7-1:1.6: ttyACM3: USB ACM device
7. Copy the file TIInit_7.6.15.bts to the /lib/firmware folder of the computer.
8. Install jumper JP86(labeled “BT_EN”), then remove it again to toggle the Bluetooth Enable signal for the
MTPCIE.
9. Enter the following string, substituting the computer's tty port that corresponds to uart port B on
MTPCIE-DK1:
hciattach -s 115200 /dev/ttyACM1 texas 3000000
10. On the Linux computer, enter:
hciconfig -a name
Example Response
ptg@ptg-desktop:~$ hciconfig -a name
hci0:
Type: UART
BD Address: 1C:E2:CC:04:5C:C2 ACL MTU: 1021:4 SCO MTU:
180:4
UP RUNNING PSCAN
RX bytes:1013 acl:0 sco:0 events:30 errors:0
TX bytes:883 acl:0 sco:0 commands:30 errors:0
Features: 0xff 0xfe 0x2d 0xfe 0xdb 0xff 0x7b 0x87
Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3
Link policy: RSWITCH HOLD SNIFF PARK
Link mode: SLAVE ACCEPT
Name: ''
Class: 0x4a0104
Service Classes: Networking, Capturing, Telephony
Device Class: Computer, Desktop workstation
HCI Ver:
(0x6) HCI Rev: 0x0 LMP Ver: (0x6) LMP Subver:
0x1f29
Manufacturer: Texas Instruments Inc. (13)
11. Verify the remote serial Bluetooth device is configured to wait for a connection.