Multitech MultiConnect MTPCIE-BW, Developer'S Manual

Page: 73 / 88

INSTALLING DRIVERS FOR NON-UIP HSPA+ DEVICES
MultiConnect
®
PCIe MTPCIE-H5/MTPCIE-BW Developer Guide 73
2. Right-click on the Telit Mobile Modem and select Uninstall.
3. Select Delete the driver software for this device and click OK .
4. Repeat the removal steps to uninstall each Telit port and the Telit Universal Serial Bus Control.
Developer Note
By default each time an H5 or G3 device with a different IMEI value is connected using this USB driver, the
operating system will not require searching for the drivers again and uses the same ports created in a previous
installation. To prevent this, use the utility included with the driver download to manage port creation as follows.
To enable USB IMEI identification, where the operating system creates a new set of ports with different COM
enumeration for each H5 device with a different IMEI value:
1. Uninstall the driver if already installed.
2. Double-click the enable USB IMEI file for your model in the folder where you extracted the driver files.
For H5: H5_enable_USB_IMEI_indentification.reg
For G3: G3_enable_USB_IMEI_indentification.reg
3. Install the driver as normal.
To disable USB IMEI identification (driver default setting):
1. Uninstall the driver if already installed.
2. Double-click the disable USB IMEI file for your model in the folder where you extracted the driver files.
For H5: H5_disable_USB_IMEI_indentification.reg
For G3: G3_disable_USB_IMEI_indentification.reg
3. Install the driver as normal.