Multitech ISI4608, User Manual

Page: 41 / 77

41
Chapter 3 - Driver Installation
2. *Error: ISI4608 rejected the load header*
*Error: ISI4608 got out of sync*
*Error: ISI4608 verify failed at address X*
*Error: Expected X received Y*
*Error: Verify got out of sync*
All the above errors represent problems with the file server not being
able to communicate with the ISI4608. Make sure that you do not
have any other device residing in the system at the same I/O address
you have chosen for the ISI4608. Power down the server, make sure
that the ISI4608 is seated properly in the system slot. Power up the
file server and try to load the AIO driver again. If the problem persists,
contact the Multi-Tech Technical Support team.
SCO Open Server 5 Driver Installation
The ISI driver for SCO Open Server 5 is shipped on CD-ROM (FAT file
system) and can also be downloaded from the Multi-Tech web site.
In both cases, the driver files are compressed (“tarred”). Users
installing from the CD-ROM should begin at “To install from CD-
ROM” directly below. Users installing from a floppy disk should skip
down to “To install driver from floppy disk” later in this section. The
filename of the SCO5 driver in its tarred form is sco50x.tar.
This present installation section is task-oriented with minimal
explanation of procedural steps. The section
Multi-Tech Installation
Script, which immediately follows this section, presents additional
details to aid in installation.
To install from CD-ROM:
# mount -r /dev/cd0 /mnt
# cd /mnt
# cd servcard/drivers/sco50x
#cp sco50x.tar /
# cd <ENTER>