Multitech ISI4608, User Manual

Page: 40 / 77

40
ISI4608 Owner's Manual
COPY E:\SERVCARD\DRIVERS\NOVELL\AIOSIX.NLM F:\SYSTEM
If you have downloaded the ISI driver from the MultiTech web site
onto a diskette, use this command:
COPY A:\NOVELL\AIOISIX.NLM F:\SYSTEM
To load the driver, go to the system or PC console (where the ISI card
is installed) and enter the following at the prompt:
LOAD AIOISIX [port=W] [interrupt=X] [name=Y] [note=Z]
The I/O Address DIP Switch and the IRQ Jumper Block are at the top
middle of the ISI4608 circuit board and on the component side.
To install the ISI card scripts, copy aiomdms.mdc to
f:\system\aio\directory. Click Yes to overwrite the existing
aiomdms.mdc file.
Configuring Ports for NetWare Connect
When the driver is installed, it will allocate 8 consecutive COM ports
for the ISI4608 card.
To set up NetWare Connect ports, enter LOAD NWCCON at the
NetWare console prompt. LOAD NWCCON opens the NetWare
Connect Configuration Utility. Select the appropriate menu options
(modem type, speed, flow control, etc.).
Removing the Driver (Novell)
In Novell, remove file AIOISIX.NLM from the system directory and
make the appropriate changes to the
Autoexec.ncf file.
Error Messages
1.
*Error: An ISI4608 does not seem to appear at
address X*
This means that the driver could not find the ISI4608
residing at the address X. Make sure that there is no other
device in your system at the same I/O address. Make sure
that the ISI4608 is seated properly in the system slot.