![background image](http://html1.mh-extra.com/html/multiquip/rx-1510-c/rx-1510-c_operation-manual_1855069064.webp)
RX 1510-C/-I/-CI
– 64 –
SI
SM
NOTE
The addresses at the transmitter and receiver must correspond.Transmitter and
receiver are factory set to address 5.
(only for machines with infrared control)
Setting the transmitter address on the machine controller:
1) Fold the operating panel back.
2) Remove the plug
SM
from the machine controller with a screwdriver
entfernen.
3) Set in the required address by turning the arrow with a screwdriver.
Setting the transmitter address on the infrared control:
Remove the plug „SI“ from the infrared control with a screwdriver entfernen.
• Set the same address as on the machine controller by turning the arrow with
a screwdriver.
Start-up
Summary of Contents for RX 1510-C
Page 2: ...proposition 65 warning Diesel engine exhaust and some of...
Page 18: ...RX 1510 C I CI 18 4 4 7 m 2 76 m 4 2 5 m 2 98 m 30 85 cm 63 cm 1 2 2 Turn radius Speci cations...
Page 24: ...RX 1510 C I CI 24 2 Safety instructions Safety instructions...
Page 36: ...RX 1510 C I CI 36 Use hearing protection Safety instructions...