![background image](http://html1.mh-extra.com/html/multiquip/rx-1510-c/rx-1510-c_operation-manual_1855069055.webp)
RX 1510-C/-I/-CI
– 55 –
1
2
3
6
4
9
8
7
5
N
SI
4.4.4 Infrared
transmitter
The infrared control is used to operate the machine with infrared control. Solar
cells supply the electrical current. Therefore, no batteries are required to operate
the infrared transmitter. The infrared transmitter is equipped with freely selectable
addresses, in order to transmit the transmitter signal. The machine controller
must be set to the same address as the infrared transmitter. The thumb wheel
is located under the square plug
SI
. This can be screwed off with a screwdriver.
The addresses can be set with a small screwdriver by turning the arrow in the
middle. If several machines are operating within the same work area, then the
machines must be used with differently set addresses. Up to four addresses are
available. Therefore, up to 4 machines can be operated by infrared at the same
time within the same work area. The addresses 6 to 9 are without function.
Pos
Function
1
Fast gear on/off
2
Driving forward
3
Steering angle left
4
large amplitude
5
Driving backwards
6
Steering angle right
7
low amplitude
8
Start
9
Machine off
N
Neutral position
Display and operating elements:
Summary of Contents for RX 1510-C
Page 2: ...proposition 65 warning Diesel engine exhaust and some of...
Page 18: ...RX 1510 C I CI 18 4 4 7 m 2 76 m 4 2 5 m 2 98 m 30 85 cm 63 cm 1 2 2 Turn radius Speci cations...
Page 24: ...RX 1510 C I CI 24 2 Safety instructions Safety instructions...
Page 36: ...RX 1510 C I CI 36 Use hearing protection Safety instructions...