MULTIQUIP Power WHISPERWATT DCA-220SSJ, Operation And Parts Manual

Page: 45 / 114

DCA-220SSJ/SSJU — OPERATION AND PARTS MANUAL — REV. #0 (02/04/14) — PAGE 45
1
Maximum Amps
Table 10 shows the maximum amps the generator can pro-
vide. DO NOT exceed the maximum amps as listed.
How to Read the Output Terminal Gauge.
The AC ammeter and AC voltmeter change-over switches
on the control panel
DO NOT effect the generator output.
They are provided to help observe how much power is being
supplied, produced at the UVWO terminals lugs.
When the voltage change-over board (Figure 16) is jumpered
for
3Ø,
240V operation place the AC Voltmeter Change-
Over Switch (Figure 17) to the W-U position and the AC
Ammeter Change-Over Switch
(Figure 19) to the U or W
position. Use the AC voltmeter or AC ammeter (Figures 18
and 20) to read the output on the selected leg of the UVWO
terminals.
Figure 17. AC Voltmeter
Change-Over Switch
Figure 18. AC Voltmeter Gauge
(Volt reading on W-U Lug)
Figure 20. AC Ammeter
(Amp reading on U lug)
Figure 19. AC Ammeter
Change-Over Switch
DCA-220SSJ/SSJU — GENERATOR OUTPUTS/ GAUGE READING
s p m A m u m i x a M r o t a r e n e G . 0 1 e l b a T
l e d o M J S S 0 2 2 A C D
e g a t l o V d e t a R s p m A m u m i x a M
e s a h P e l g n i S
tl o V 0 2 1
) e ri w 4 ( s p m a 9 . 8 8 4
e s a h P e l g n i S
tl o V 0 4 2
) e ri w 4 ( s p m a 4 . 4 4 2
e s a h P e e r h T
tl o V 0 4 2
s p m a 9 2 5
e s a h P e e r h T
tl o V 0 8 4
s p m a 4 6 2
The ammeter gauge will only show a reading when the
output terminal lugs are connected to a load and in
use.
NOTICE