KUBOTA WATER HEATER KIT INSTRUCTIONS (MULTI-MODELS) P/N 14254 — REV. #0 (12/14/15) — PAGE 2
BATTERY CABLE DISCONNECTION
1. Disconnect the negative cable (
BLACK
) from the
negative terminal on the battery. See Figure 2.
Figure 2. Battery Cable Disconnection
NEGATIVE
(BLACK)
POSITIVE
(RED)
HEATER ELEMENT PREPARATION
1. Locate the Kubota Water Heater element and cordset
(Figure 3) in the kit.
Figure 3. Heater Element and Cordset
2. Thoroughly clean both ends of the heater element
and cover each side with masking tape as shown
in Figure 4. Make sure the heater element body is
exposed.
Figure 4. Tape Masked Heater Element
3. Paint the heater element body with a high temperature
resistant paint to protect the heater element against
corrosion. Allow the paint to fully dry.
4. Once the paint has dried on the heater element
body, remove the masking tape from the heater side
(non-threaded) of the heater element.
HEATER
ELEMENT
HEATER
ELEMENT
CORDSET
HEATER
ELEMENT
MASKED
END
HEATER
ELEMENT
MASKED
END
HEATER
ELEMENT
BODY
NOTICE
DO NOT
remove the masking tape from the threaded
end of the heater element until the heater element is
ready for cordset installation.
