KUBOTA WATER HEATER KIT INSTRUCTIONS (MULTI-MODELS) P/N 14254 — REV. #0 (12/14/15) — PAGE 1
Kubota Water Heater Installation Instructions
(Multi-Models)
The following instructions are intended to assist the user in the installation of the Kubota Water Heater Kit. It is
recommended the following procedure be performed by a Multiquip Authorized Service Center (ASC) or by a
Multiquip Field Service Manager. Generator or engine failures caused by improper field installation are not covered
under a Multiquip Limited Warranty. Please read all assembly instructions before installing the kit.
REQUIRED TOOLS
Hammer
Ratchet W/ Extension
1 inch socket
6-8 inch hole/hammer punch
Channel Lock Pliers
Tape
Paint (High Temperature Resistant)
PARTS
Verify that all parts are accounted for. See Figure 1 and
Table 1.
Figure 1. Kubota Water Heater Installation Kit
DA/DAC KUBOTA
WATER HEATER
INSTALLATION
INSTRUCTIONS
3
2
4
1
WORK SAFELY!
Only a
qualified service technician
with proper training
should perform this installation. Follow all shop safety rules
when performing this installation.
PREPARATION
1. Make sure generator is turned off and engine is cool.
2. Place the generator in an area free of dirt and debris.
Make sure it is on secure level ground. If trailer
mounted, place chock blocks underneath each wheel
to prevent the generator from rolling.
3. Open the right side cabinet panel to gain access to the
engine fuel supply and battery location.
Table 1. Kubota Water Heater Installation Kit
Item
No.
Part
No.
Description
QTY.
Remarks
1
13543
Kit, Kubota Water Heater, Multi-Models
1
Includes
items 2-3
2
14062
Heater, 400W, 115VAC, Kubota Block
1
3
14254
Instructions, Kubota Water Heater
1
4
777055
Carton, 6" x 6" x 6"
1