![background image](http://html.mh-extra.com/html/multiquip/cd6ce13h18/cd6ce13h18_operation-manual_1855305017.webp)
STOW CUTTER 1 CE — OPERATION MANUAL — REV. #2 (12/20/07) — PAGE 17
Failure to thoroughly inspect the diamond blade (Figure 10)
for operational safety could result in damage to the blade or
the saw, and may cause injury to the user or others in the
operating area. Discard damaged or worn blades and
replace with fresh blade.
Figure 10. Diamond Blade
1
.
Drive Pin Hole –
A commonly located hole on the diamond
blade core that prevents operational blade slippage
between the inner & outer blade flanges (collars). Inspect
the diameter of the hole to ensure there is no distortion,
and that a snug fit develops between the hole and drive
pin.
2
.
Stress Relief Holes (Gullets) –
Check the steel core for
cracks that may have propagated from the slots and/or
gullets. Cracks indicate extreme fatigue failure and if sawing
continues, catastrophic failure will occur.
3
.
Edge Of The Steel Core –
Check the diameter edge for
discoloration (blue oxidation) indicating an overheating
condition caused by insufficient cooling water/air.
Overheating of blades may lead to loss of core tension
and/or increase the possibility for blade failure. Check to
make sure the steel core’s width is uniform about the rim of
the blade, and not succumbing to an “under cutting”
condition brought about by highly abrasive material or
improper under cutting core protection.
4
.
Directional Arrow –
Check to ensure that the blade is
oriented properly on the spindle for sawing. Reference the
directional arrow on the blade and place it so the direction
of rotation “downcuts” with the turn of the shaft.
5
.
Diamond Segment or Rim –
Ensure there are no cracks,
dings, or missing portions of the diamond segment/rim.
DO
NOT
use a blade that is missing a segment or a portion
of
the rim
. Damaged and/or missing segments/rims may
cause damage to your saw, and injury to the user or others
in the operating area.
6
.
Specifications –
Ensure that the blade specifications, size,
and diameter properly match up to the sawing operation.
Wet blades must have water to act as a coolant. Utilizing a
diamond blade not matched properly to the task may result
in poor performance and/or blade damage.
7
.
Arbor Hole –
It is essential that the arbor hole diameter
properly matches the shaft arbor, and that it is free from
distortions. Correct blade flanges (collars) must be used.
The inside face of the flanges must be clean & free of debris.
An out of round arbor condition will cause damage to the
blade and the saw.
8
.
MAX RPM –
This RPM reference is the maximum safe
operating speed for the blade selected.
NEVER
exceed
the max RPM on the diamond blade. Exceeding the MAX
RPM is dangerous, and may cause poor performance and
may damage the blade. All blades used must be designed
for the maximum spindle RPM.
STOW CUTTER 1 CE SAW— BLADES
SPECIFIC TOOLS TO BE USED
This saw is to use tools (blades) as follows:
Steel Core Segmented or Continuous Diamond Rim
Cutting Wheel.
Any other type of tool is not to be used. See Table 4 for specific
blade usage for material.
WARNING