MULTICOM 5 PLUS INSTALLER MANUAL
5
Quick Start Guide
The following gives an overview of the basic installation steps.
Further details on programming options and methods can be found
in the proceeding sections of the manual.
1.
Connect the three antennas
to the panel.
1.
RF Automation Transmitter – Smallest Antenna
2.
GSM – Largest Antenna
3.
Bluetooth - Medium Antenna
STEP 2 & 3 IMPORTANT FOR PANEL PLACEMENT
2.
Connect the battery
terminal block to the corresponding
pins on the PCB. Place the battery on the floor of the
panel and connect the positive (red) and negative
(black) battery leads to the corresponding terminals on
the battery.
3.
Test the GSM signal
in the desired mounting location by
holding it against the wall and observing the signal
strength. The signal must be 2 bars or greater for
operation. Once test is complete remove the battery
terminal block and leave disconnected for the following
steps.
4.
Mount the panel
to the desired location. Use the
provided mounting template to locate screw holes and
establish antenna clearance.
