MULTICOM 5 PLUS INSTALLER MANUAL
20
CID Event Map
You will need to have your monitoring station map the following events for the account (Fax
this list) if Multicom is not already in their Contact ID list.
IMPORTANT NOTE:
The MC5P will send
'pending alarms' (Event type 6) with test reports, you may need to include pending alarm
notifications to come to the operator.
X = Event, Restore or Previous Alarm (E,R or P)
Event
Description
CID Offset (Zone)
Tamper
External Tamper Triggered
18
X
950999
00
Zone 1
Zone 1 Triggered
18
X
950999
01
Zone 2
Zone 2 Triggered
18
X
950999
02
Zone 3
Zone 3 Triggered
18
X
950999
03
Zone 4
Zone 4 Triggered
18
X
950999
04
PSTN Fault
Alarm
PSTN voltage has been lower than the
programmed voltage for the programmed time
18
X
950999
05
Battery Fault
Alarm
The battery voltage has been outside 'normal
operating limits' for the programmed period of time
18
X
950999
06
GSM Fault
Alarm
GSM has not been connected to the network for
the programmed period of time
18
X
950999
07
GPRS Fault
Alarm
GPRS has been unable to communicate with the
servers for the programmed period of time
18
X
950999
08
Eth Fault alarm
Ethernet has been unable to communicate with
the servers for the programmed period of time
18
X
950999
09
AC power Fault
AC has not been detected for the programmed
period of time
18
X
950999
10
Test Report
Test report occurs at the programmed interval
18
X
950999
11
Poll Alarm
Unable to poll for the programmed period of time
18
X
950999
12
PGM Update
Remote software update
18
X
950999
13
Alarm buffer
Overflow
The MC5P has previously had to many contact ID
alarms in its buffer, some alarms have been lost
18
X
950999
14
COMM's Failure
Multicom was previously unable to communicate
some alarm events
18
X
950999
15
Service
Required
Contact your supplier for servicing requirements.
18
X
950999
16
Zone Lock out
One or more zones has repeatedly been triggering
in a short period of time, this will lock out the event
until the zone stops repeatedly triggering.
18
X
950999
17
Multicom Power
Point
Notification
This notification report occurs when the MC5P starts
power cycling the Multicom Power Point. It will
restore once Ethernet is restored.
18
X
950999
18
ComWatch Fail
Alarm panel has been unable to deliever contact
ID alarms via the standard PSTN/GSM path directly,
the Multicom is now the priority path (Ref Opt 5, 12
and 37).
18
X
950999
20
