Multibor - Suite technology
The quality and the speed of performance of the procedures depend
both on the skills of a master and on the correct combination of the
equipment and materials as well as on the output power of the
milling cutter, the shapes and sharpness of the caps, the tool rotation
speed, and the pressure on the nail plate or the foot of a client. The
Multibor-Suite technology combines the technical capabilities of the
equipment, the specifics of usage of the tools for machine-assisted
nail care, the present-day requirements of a client, and the skills of a
master. Your milling cutter operates according to the Multibor-Suite
technology in the Program Mode. This enables you to use the table
for correct operation of the device in accordance with a pre-selected
program for a specific procedure. The processor will further
automatically select the required speed, the output power, and the
torque, and it will also supervise and control all required changes in
the course of the operation, smoothly adapting to your manner of
performing the procedure.
The additional opportunities of Multibor-Suite
It is only the MULTIBOR Suite Podolog device family that has two
control channels and two connections for two engines, which can be
controlled in turns. This feature would for instance be useful for
chiropodists.
Thru the usage of the additional engine of the NAIL type jointly with
the "Natural Nail" or "Pedicure" programs, it can select the operating
modes for complex podiatric cases.
Besides, MULTIBOR Company can supply the Podolog-type devices
with additional therapeutic engines required for the operation with
the Omnicut heads under the mechanical nail care technology with
cuticles trimmed.
Attention!
The Omnicut head is not included in the package.
This tool should be purchased separately.
18
Program Control Mode "Programs"
Press the 'M-button' to select operation modes under the preset
programs.
While in the 'Programs' mode, the display shows a character to
indicate a specific program and a digit to indicate the program's
number.
Select a desired program by rotating the Manipulator.
Press the center of the Manipulator for one time to start the rotation.
Attention!
The rpm rates and the programs cannot be changed on
the go. Stop the rotation to change a program. While a program is in
operation, it is only possible to change the rotational direction by
pressing the center of the Manipulator for two times at a run same as
you double-click on a computer mouse.
Very important!
Follow the safety precautions!
It is allowed to unlock the clamp or to change a tool only after the
rotation is fully stopped.
Program H6
“Reverse” - OFF
Program P7
“Reverse” - ON
