1. To switch on the rotation, press the center of the Manipulator
once
2. To increase the rpm rate, rotate the Manipulator clockwise
3. To decrease the rpm rate, rotate the Manipulator counterclockwise
4. To alter the rotational direction (the reverse function), press the
center of the Manipulator twice at a run same as you double-click on
a computer mouse
5. To switch off the rotation, press the center of the Manipulator once
again
You can change the rpm rates and the rotational directions
on the go.
16
Manual Mode
Switching between the manual and program modes is performed by
pressing the 'M-button' and is followed by an audible signal.
Switching between the modes is only possible when the tool
rotation is off.
In the Manual mode, the display shows only two or three digits,
which mean the tool rotation speed in thousands of revolutions per
minute (rpm).
The rotation direction is shown by the "running arrow" in the first
section of the indicator on the Display.
Attention!
The weight and mechanical balance of a tool have
significant influence on the vibration of the milling cutter. There is a
risk of damaging a tool at the speeds exceeding 30,000 rpm. The
milling cutter has two levels of rotation adjustment in order to
decrease the probability of accidents.
1. Fast and abrupt adjustment done literally during a single
revolution of the Manipulator for the speeds of up to 30,000
rpm only. In this case, a short audible signal indicates that the
first level speed is reached.
2. The increase of the speed exceeding 30,000 rpm will be done
slower. Actually, the Manipulator needs to be rotated for a
longer time while the speed increases slower.
Speed 9,700 rpm
“Reverse” - OFF
Speed 25,300 rpm
“Reverse” - ON
