72
I-Wave PE653-PE953 Installation Guide
Copyright © 2010 Intermatic, Inc.
What to do
If it doesn’t work
Reference/Procedure
Verify that the PE653 Device
is operational and working.
Verify that power is ON to
the PE653 Device.
Turn the main circuit breaker that feeds the panel to the
1.
ON position.
Use a voltmeter to verify that voltage is present at
2.
terminals 1 & 2.
Verify the Voltage Selector
Switch is in the proper
position.
Voltage Selection Switch should be in the 120V or 240V
position corresponding to the voltage reading observed in
Step 2 above.
Verify that the F1 Fuse is
not blown.
Turn OFF the power to the PE653 Device.
1.
Remove the fuse and test with an ohmmeter or fuse
2.
tester.
Replace the fuse if good or install a new fuse.
3.
Turn the power to the PE653 Device ON.
4.
Verify that each circuit is
operational.
Press the ON switch for Circuit #1.
1.
Verify that the Load ON indicator for Circuit #1 is ON.
2.
Press the ON switch for Circuit #2.
3.
Verify that the Load ON indicator for Circuit #2 is ON.
4.
Press the ON switch for Circuit #3.
5.
Verify that the Load ON indicator for Circuit #3 is ON.
6.
Press the ON switch for Circuit #4.
7.
Verify that the Load ON indicator for Circuit #4 is ON.
8.
Press the ON switch for Circuit #5
9.
Verify that the Load ON indicator for Circuit #5 is ON.
10.
Turn OFF all Circuits.
11.
Verify that the electrical
wiring for each load is
correct.
Refer to the appropriate wiring diagram in Section 3,
starting on page 13.
What to do
If it doesn’t work
Reference/Procedure
Verify that the PE953
Hand-Held Controller is
communicating with the
PE653 Device
Test communications
between the PE953 and the
PE653.
Press and release any button on the Hand-Held
1.
Controller to wake it from sleep.
Press the number 1 switch on the PE953.
2.
Verify that Circuit #1 turns ON.
3.
Press the number 1 switch again to turn OFF.
4.
Press the number 2 switch on the PE953.
5.
Verify that Circuit #2 turns ON.
6.
Press the number 2 switch again to turn OFF.
7.
Repeat for all 5 circuits.
8.
Review Section 4:
Programming the PE953
Hand-Held Controller
starting on page 41.
Refer to page 43:
Linking the Hand-Held Controller to the
PE653 Receiving Device.