Multi-Tech MT5634ZPX, Owner'S Manual

Page: 42 / 108

MT5634ZPX
42
Owner’s Manual
Note: To change the modem’s default initialization string, type
the new commands in the software’s terminal window,
adding the command &W to store the new commands in
the modem’s nonvolatile memory, e.g., AT&FS0=1&W.
You then can simplify your initialization string to ATZ^M.
5. If you are using legacy software, select the port the modem
is connected to (normally, COM3).
6. For maximum throughput when using data compression, set
the serial port baud rate, or DTE rate, to 115,200 bps. (In
Windows 95, select
Start, Settings, Control Panel, Modems,
Properties.)
7. If your legacy software has an autobaud selection, make
sure it is disabled. Autobaud is for much older modems and
can cause problems if enabled.
8. If the software allows you to edit the no-connect messages
(
NO CARRIER, BUSY, NO ANSWER, NO DIALTONE),
make sure there is no space between
DIAL and TONE in
NO DIALTONE.