M
UGNAI N I
®
MUGNAINI SERIES
GAS FIRED OVEN MANUAL
Mugnaini Imports, Inc.
11 Hangar Way, Watsonville CA 95076
888.887.7206 │ 831.761.7167 │ Fax: 831.728.5570
www.mugnaini.com │ [email protected]
PAGE 15
9.2 CONTROL BOX
The Spitfire gas burner system is a sophisticated controller that can be used in either a Manual mode or an
Automatic mode with Set Point. In addition, the size of the flame can be regulated independently of the
oven temperature.
9.2.1 POWER BUTTON
The power switch is the button in the top left corner of
the control box. A green light will be illumined when the
burner is on.
9.2.2 OVEN TEMPERATURE
The oven temperature is display with LED numbers in the
middle of the control box. The Spitfire burner system reads
the oven temperature in front of the burner using a thermal
couple. While this number is accurate, it is primarily used as
a guide for setting the burner not for cooking. See Cooking
Environments for details.
9.2.3 SET POINT
The Set button is pressed to change the ‘Target
temperature’ or set point of the burner when in Auto mode.
Press Set and then use the up and down arrows to change
the set point. Press Set again to lock in the set point. The
Spitfire burner will automatically raise and lower the flame
to maintain that temperature.
NOTE: The actual temperature inside the oven will be different than the temperature displayed on the
control box. This Set Point should be used in conjunction with an infrared thermometer to balance
the oven for the desired cooking environment. Test various set points in 10 degree increments to
determine the set point that achieves the desired floor temperature.
9.2.4 RESET BUTTON
If the oven loses its flame, the Reset button will be illumined. Press the Reset button to relight the burner.
If the burner goes out three times in a row contact Mugnaini service department to rectify the problem.
9.2.5 FIRE CONTROL
The size or intensity of the flame can be changed by pressing the up or down arrows to achieve the
desired flame.
9.2.6 MAX BUTTON
Press the Max button to allow the oven to run at maximum power. The flame can be adjusted manually by
using the Fire Control up and down arrows.
9.2.7 AUTO BUTTON
Press the Auto button to manage the oven based on the set point. See Set Point for details.
9.2.8 MIN BUTTON
Press the Min button to run the oven with the smallest flame. Use this mode when pre-heating an oven or
to keep a hot oven stable between lunch and dinner service.
