4. Select which AIU the switch is added to. (See the
explanation for counting AIUs in the Programming
Accessories section on page 13.)
5. Select the AIU port (SW1-SW10) the switch is
wired into.
Programming Switches (con'd)
Select AIU To Use
Select Switch #
Select Characters For
Accessory Name
(Highlighted By Brackets)
Select TIU To Use
1
2
3
SEL AIU TO USE
SW !
SW 2
SW 3
SEL SWITCH #
[A]BCDEFGHIJKLMNO
PQRSTUVWXYZ#- &
O123456789<D
ENTER ACCESS NAME
!: siding switch 1
2: siding switch 2
3: yard switch 1
ALL S/U
6. The LCD prompts you to name the switch, and an
alphanumeric character set is displayed. Use the
thumbwheel to scroll through the character set, and
when the character you want to type next is bracketed,
press the thumbwheel to select it. You may give the
switch a name up to 16 characters long. Select the “D”
at the end of the character set to signify that you are
done with this function
(See page 13 - 14 for more
informationon naming accessories).
The switch will now show up, by the name you have
assigned, on the switch screen when you press the DCS
handheld’s SW button.
See the DCS System Operating Instructions for complete
instructions on editing and renaming switches and for
instructions on adding and numbering TIUs.
DCS Accessory Interface Unit
16