MTD 452J Series, Operator'S Manual

Page: 8 / 20

8 S
ection
3 — A
SSembly
& S
et
-U
p
2. Align the chipper chute over the weld studs, so the slot in
the bottom of the chute is facing down. See Fig. 3-6.
3. Secure chipper chute with the three cupped washers
(cupped side against the chipper chute) and hex nuts
previously removed. See Figure 3-6. Tighten the nuts at this
time.
Figure 3-6
2. Remove the hex lock nut, spacers, and hex bolt from the
top of the impeller housing. See Figure 3-3B.
3. Align the chute deflector in position on the discharge
opening and insert hex bolt with spacer through hinge on
chute deflector (spacers fit inside of hinges). See Figure
3-4A.
A
B
C
Figure 3-4
4. Place second spacer over hex bolt inside other hinge and
secure with hex lock nut. See Figure 3-4B.
5. Secure both sides of chute deflector to impeller housing
using wing knobs previously removed. See Figure 3-4C.
Chipper Chute
1. Remove the three cupped washers and hex nuts from
weld studs around the opening on the side of the impeller
housing. See Figure 3-5.
Figure 3-5