f)
Use a soft cloth for cleaning.
g)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as these may damage the surface of the device material.
h)
If the surface of the inflatable boat is contaminated with any operating fluids
from the engine, the contaminated places should be immediately and
thoroughly cleaned.
i)
Store in cool and shaded places, free of moisture. Before storing, the inflatable
boat should be washed, then thoroughly rinsed (especially when used in salt
water) and finally completely dried. It should also be vacuumed of sand and
other residual dirt, and the chambers should be deflated.
3.3.1 Repairing leaks in inflatable boat sheathing
IMPORTANT:
due to temperature fluctuations, the air pressure in the chambers of the
inflatable boat can fluctuate, making it sometimes appear soft, as if air has escaped.
This is normal and for a proper diagnosis the sheathing should first be checked for leaks.
Water with diluted soap or washing-up liquid can be used to detect leaks in the boat
sheathing. First, inflate all chambers and make sure each air valve is tightened securely
(use the wrench provided). Then, spray or pour the prepared solution on the given place
in the sheathing and observe if there are any air bubbles on it. If we notice any, then:
•
Repair of minor leaks
(holes up to 1/8 inch or 3 mm) - deflate the air from the
boat , clean and degrease the area, then pour a drop of glue so that it covers the
entire hole. Wait at least 12 hours and then check the repaired area for leaks
before using the dinghy.
•
Repair of major leaks
(bigger than the needle hole) - thoroughly clean the area
around the leak. Cut a fitted piece of patch so that it extends about 1/2 inch (1.3
cm) above the outline of the hole. Apply glue to the underside and around the
area to be repaired so that it should be completely covered with glue. Wait 2-4
minutes for the adhesive to set. Apply the patch to the area being repaired, press
it tightly and evenly. Wait at least 12 hours for the glue to dry. After drying, apply
glue to the corners of the patch and wait at least 4 hours until it dries. Check the
tightness of the repaired area once more before using the boat.
DISPOSAL OF USED DEVICES.
At the end of its service life, this product must not be disposed of with normal
household waste but must be taken to a collection point for recycling of electrical
and electronic equipment. This is indicated by the symbol placed on the product,
operating instructions or packaging. The materials used in this device are
recyclable according to their labelling. You make an important contribution to
protecting our environment by reusing, recycling or otherwise disposing of used
equipment.
