Produkt spełnia wymagania odpowiednich norm
bezpieczeństwa.
Przed użyciem należy zapoznać się z instrukcją.
Produkt podlegający recyklingowi.
EN
6
3.1. DEVICE DESCRIPTION
PRO-A 10
1.
Mounting grip
2. Housing
3.
pressure line
4. lock
5. Handle
6. Crank
3.2. PREPARING FOR USE
PRO A-10, PRO- A 20, PRO-A 15
The Automatic Hose Reel must be installed on a wall or
ceiling before use. For this purpose, the mounting grip must
be fastened with screws to the selected surface. In case of
the PRO-A 20 and PRO-A 15 model it is necessary to screw
the grip to the wall and then to place the hose reel onto it
and to lock it with the mandrel. It is recommended to mount
the device at a height of min. 80 cm above the floor.
PRO- A 30
For model PRO-A 30, mount the unit on a clean workbench
without dirt and moisture.
3.3. DEVICE USE
•
In order to unwind the pressure line, it is necessary to
pull and unwind it until the desired length is reached.
•
In the course of winding, it is necessary to hold the line
end so that it will not be damaged.
•
Do not pull the pressure line when it is fully unwound
from the drum. This may cause locking the retractor or
damage of the line itself.
•
Before unwinding and winding the pressure line, it is
necessary to always make sure that the supplying and
receiving devices have been unfastened.
3.4. CLEANING AND MAINTENANCE
•
Before starting to clean the device it is necessary to
disconnect it from the source of the compressed air
supply.
•
Use cleaners without corrosive substances to clean
each surface.
•
Dry all parts well after cleaning before the device is
used again.
•
Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
3
4
1
2
5
1
2
4
3
PRO-A 20
b)
Keep the device out of the reach of children.
c)
Device repair or maintenance should be carried out
by qualified persons, only using original spare parts.
This will ensure safe use.
d)
To ensure the operational integrity of the device, do
not remove factory fitted guards and do not loosen
any screws.
e) The air should be used to supply the unit, it is
forbidden to use other gases..
3. USE GUIDELINES
The device is designed to extend the distance between
the compressed air supply, e.g., a compressor, and the
receiving device.
The user is liable for any damage resulting from non-
intended use of the device.
PRO-A 15
PRO-A 30
3
2
4
5
1
3
5
6
2
Rev. 15.06.2021
Summary of Contents for PRO-A 10
Page 21: ...21 NOTES NOTIZEN Rev 15 06 2021 ...
Page 22: ...22 NOTES NOTIZEN Rev 15 06 2021 ...
