6
maintenance. On & Gone is a powerful mold stain remover, in order to extend the life of
the sprayer, after each use,
do not leave any chemicals in the spray tank, gun, tip or
tube. After each job or end of day, BP Sprayer must be completely cleaned of
residual chemicals.
This will extend the life of the sprayer and maintain its
performances.
Recommended Steps for Proper Maintenance
1)
Empty sprayer tank of all residual chemicals
2)
Fill the tank with 2 gallons of clean water, rinse the strainer thoroughly and close
the lid
3)
Agitate or shake the sprayer to rinse the inside of the sprayer completely
4)
Spray water (at least 1 gallon) through the BP Sprayer so residual chemicals in the
spray gun, hose and pump intake are completely removed
5)
Dispose of residuals water (residual poses no risk for environment)
6)
Remove atomization tips, and rubber “O” ring. Clean thoroughly in water and dry
with a clean dry towel
How to Operate the BP Sprayer
1)
OPERATION OF RECHARGER
.
The battery of the BP Sprayer has been fully charged upon delivery. However, check the
power level of the BP Sprayer with a voltage meter. If the indicator reads yellow or red
(<12V), a supplementary charging is required. The battery can be charge by plugging the
charger into the charging socket (located on the side of sprayer). The indicator light will
turn green to indicate the battery has been fully charged.
2) If the sprayer has been used for a short time it is not necessary to recharge. If it has
laid unused for a long period, (such as one month or two) it must be fully discharged
before being fully charged in order to maintain the capacity and service life of the battery.
