10
OPEN
CLOSE
Jet (inside)
Adjusting Knob
open (max.)
close (min.)
1.
Heat Button: Activates Heating and Filtering system at the same time
2.
Jet Button: Activates Jetting system
3.
filter button
4.
TEMP Button: Set and show water temperature
5.
Higher temperature
6.
Lower temperatrure
LED Display: Once powered-up, the LED displays the current water temperature automatically.
Temperature Adjustment Buttons: Increase Decrease
Pressing the Temperature Increase or Temperature Decrease buttons will cause the LED to flash. When
it is flashing, you can enter the desired temperature setting. If you hold these buttons down the values will
rapidly increase or decrease. The new and desired temperature setting will remain on the LED display for
5 seconds to confirm the new value.
NOTE: The set point temperature defaults to 40°C(104°F) when first plugged in.
NOTE: Temperature adjustment ranges from 20°C(68°F) to 40°C(104°F).
Water Filtration Button: This button turns the Filter Pump on and off.
The light of the water filtration button displays green the filtration system is activated.
Heat Button: Use this button to activate the heating system.
The Pump does not stop heating the Spa until the current water temperature reaches 1°C higher than the
set temperature.
After the current water temperature drops 2°C below the set point temperature the heating system will
restart.
When the light of the Heat Button displays green, the heating system is activated.
Heating system is capable of increasing approximately 1.5 to 2°F per hour.
NOTE: If the heating system is activated the filtration system will automatically start – This is normal.
Caution: Heating operation should not exceed 48 hours continuously.
Jet Button: Use this button to activate the massage jet system which has to be stopped for 2 hours
after it works for 2 hours
The light of Jet Button displays green when activated.
Adjusting the jet control knob
There are three jet control knobs on the side of the pool. Adjusting them can adjust the Power of massage
jet .
Adjusting the Jets direction
Turn the direction of the nozzles to suit your need.
FILTER
HEAT
JET
