5
Contents of the repair kit:
Jetspa instruction manual, PVC Repair patches (2pcs); Deflation tube for
pool cover (2pcs); O-Ring for control box and spa connection (2pca).
A. Site Requirements
WARNING:
The floor has to be capable of supporting the expected load.
WARNING:
An adequate drainage system has to be provided to deal with overflow water.
IMPORTANT:
Because of the combined weight of the spa, water, and users, it is extremely important that
the base where the Spa is installed is smooth, flat, level and capable of uniformly supporting this weight
for the entire time the spa is installed. If the spa is placed on a surface, which does not meet these
requirements, any damage caused by improper support will void the warranty. It is the responsibility of the
Spa owner to assure the integrity of the site at all times.
a) Indoor Installation:
Be aware of special requirements if you install the spa indoors.
The floor must be able to withstand the capacity of the spa. The floor should be a non-slip, level
surface.
Proper drainage is essential for indoor spa installation. When building a new room for the spa it is
recommended that a floor drain be installed.
Humidity is a naturally side effect with spa installation. Determine the effects of airborne moisture on
exposed wood, paper, etc. in the proposed location. To minimize these effects it is best to provide
plenty of ventilation to the selected area. An architect can help determine if more ventilation is needed.
NOTE:
Do not install the spa on carpet or other material that can be damaged by moisture.
b) Outdoor Installation
WARNING: TO AVOID THE ELECTRIC SHOCK, DO NOT USE THE SPA WHEN IT IS RAINING.
No matter where you install the spa, it’s important you have a solid support foundation. If you are
installing the spa outdoors, ensure there are no sharp objects that could damage it and that the
location is level so the spa sits stably and properly.
During filling, emptying or when in use, water may spill out of the Spa. Therefore the spa should be
installed near a ground drain.
Do not leave the Spa’s surface exposed to direct sunlight for long periods of time.
B. GFCI Test
WARNING:
RISK OF ELECTRIC SHOCK.
The GFCI plug must be tested before each use.
WARNING:
Insert the GFCI plug into a residual current device (GFCI) protected power receptacle only.
WARNING:
Before inserting the plug into a power receptacle, make sure the current rate of the power
receptacle and the fixed wiring are suitable for the Spa. Contact a qualified electrician if you cannot verify.
1.
Insert the plug into the power receptacle. (1)
2.
Press the “RESET” button. The indicator light should turn red. (2)
3.
Then press the “TEST” button. The indicator light should disappear. (3)
WARNING: Do not use if above test fails.
