13
● Make sure to set up the spa on a firm, level and smooth surface that is strong enough to support the full
weight of the filled spa and maximum occupants.
● Do not set up the spa on grass or dirt, as this increases the amount of debris entering the spa, and damage
the spa floor.
● Do not leave the spa tub exposed to direct sun light for extend period of time.
● It is recommended to install and leave the spa outside at a temperature not lower than 4°C (39°F) to ensure
the water inside the circulation system, pump, pipe are not frozen. Put a Heat Preservation Mat between the
spa bottom and the ground to prevent heat loss from the bottom of the spa and to provide better heat
retention.
● Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of any
other material that could damaged by the moisture.
● Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
Additional requirements for outdoor installation
GFCI Testing
Risk of electric shock: This product is provided with a GFCI located at the end of the power cord. The
GFCI plug must be tested before each use. Do not use the spa if the GFCI plug does not function properly.
Disconnect the power cord until the fault has been identified and corrected. Contact a licensed electrician
to correct the fault. There are no serviceable parts in side the GFCI plug. Opening the GFCI plug will void
the warranty.
!
WARNING
2.
RESET
3.
TEST
4.
Indicator area
RESET
TEST
RESET
TEST
RESET
TEST
1. Plug the machine into the mains.
2. The GFCI plug might automatically reseted. If the
RESET
indicator is not red, press the
RESET
button.
3. Press the
TEST
button on the GFCI. The GFCI indicator should shut off. If the GFCI indicator does not turn
off, the GFCI is faulty. Do not use the spa. Contact a qualified electrician to correct the fault.
4. Press the
RESET
button on the GFCI again. The indicator should turn red. If yes, the spa is ready for use.
√
PRCD doesn’t
work on faulty
sockets or plug
boards.
1.
