M S-6417 Barebone
2-10
Front Panel Connector: JFP1
The mainboard provides one front panel connector for you to connect to
the front panel switches and LEDs. JFP1 is compliant with Intel
®
Front Panel I/O
Connectivity Design Guide.
Power
LED
HDD
LED
Reset
Switch
Power
Switch
1
9
2
10
PIN
1
2
3
4
5
6
7
8
9
Pin Definition
SIGNAL
HD_LED_P
FP PWR/SLP
HD_LED_N
FP PWR/SLP
RST_SW_N
PWR_SW_P
RST_SW_P
PWR_SW_N
RSVD_DNU
DESCRIPTION
Hard disk LED pull-up
MSG LED pull-up
Hard disk active LED
MSG LED pull-up
Reset Switch low reference pull-down to GND
Power Switch high reference pull-up
Reset Switch high reference pull-up
Power Switch low reference pull-down to GND
Reserved. Do not use.
Important
Always consult the vendors for proper CPU cooling fan.
Fan Power Connectors: SYSFAN1/CPUFAN1
The Fan Power Connectors support system cooling fan with +12V. It
supports 3-pins head connector. When connecting the wire to the connectors,
always take note that the red wire is the positive and should be connected to the
+12V, the black wire is Ground and should be connected to GND. If the mainboard
has a System Hardware Monitor chipset on-board, you must use a specially
designed fan with speed sensor to take the advantage of the CPU fan control.
SYSFAN1
SE NS OR
+1 2V
GND
CPUFAN1
SE NS OR
+1 2V
GND
JFP1
Summary of Contents for AXIS 945GM - Axis - 945GM
Page 1: ...Axis 945GM Series MS 6417 V1 X Barebone G52 64171X1 ...
Page 6: ...vi WEEE Statement ...
Page 7: ...vii ...
Page 8: ...viii ...
