MAINTENANCE
Cleaning and changing nozzles
NOZZLE CHANGE
Removing the nozzle
1. Clean the powder gun as described above in Interruption
of work
2. Pull of nozzle (1) from the nozzle tube (3).
3. Unscrew the nozzle nut (2) from the gun body (4).
WA R N I N G
!
Wear parts in the powder gun, marked with a W
in the spare parts list, must be checked regularly and
replaced if necessary.
CAUTION
!
CAUTION
!
Maintenance, repair or replacement of parts may
only be performed by trained personnel of MS Powder.
For maintenance and cleaning work the controller
must be switched off at the main switch.
3
4
1
2
1
3
4
2
SCHEDULE
Daily (or at start of each shift)
• Verify all containers in hazardous area and spray area
are grounded
• Check within 6m (20ft) of the point of operation (of
the applicator) and remove or ground ALL loose or
ungrounded objects
• Inspect all work holders for accumulated coating
materials (and remove such accumulations)
Weekly
• Check resistance to ground of the work holders.
Resistance must be less than 1MOhm to true earth
ground measured at 1000V.
• Check applicator and associated equipment for any
damage. Any damaged devise must be decommissioned
at once and repaired.
Annually
• Ensure interlocks between high voltage, ventilation
and the applicator are properly functioning. If not,
repair at once.
PA-17-06-R1 (08/2018)
28 / 37
www.carlisleft.com
MAINTENANCE
EN