4
EN MS AutoHoofClean
Installing the MS AutoHoofClean
1.
Drill 2 x 8 mm holes horizontally at 345 mm (see image). Then mount the pump unit with
the 2 supplied plugs and bolts.
2.
Grab the supplied hose, mount the GK-coupling and the hose clamp onto it. Then connect
these to output 7.
3.
Put the mat at the desired location.
4.
Ensure that the hose of the pump unit runs to the mat and tie it properly to existing
installations, for example with the supplied tie wraps. Place the hose in such a way that
bends or kinds are avoided.
5.
Cut the hose to the correct length so that it can be connected to the mat. Mount the last
GK-coupling and hose clamp to the hose on the side of the mat. Then connect it to the inlet
on the mat.
6.
Make sure that clean (tap) water is fed through inlet 4.
7.
Place a jug with MS AutoHoofClean under the pump unit. Connect the transparent hose to
the dosing unit and ensure that the hose can reach all of the fluid. Connect the transparent
hose to connection 5 of the pump unit (front connection) and ensure that the hose ends up
at the bottom of the jug.
8.
Place the jug with alternative product under connection 6 (rear connection) of the pump
unit. Connect the hose to connection 6 (rear connection) and make sure that the hose
comes out at the bottom of the jug.
9.
Insert the plug (8) into the outlet.
Commissioning of the MS AutoHoofClean
1.
Disconnect the hose at inlet 7 on the pump unit.
2.
Put a bucket underneath outlet 7 to collect the liquids.
3.
Press the water button (1) until water flows out of output 7.
4.
Turn the water knob and “MS HoofClean” (2) until the transparent suction hose is full of
product and check whether a mixture of water and “MS HoofClean” comes out. Then turn
the knob back in its original position
5.
Turn the water knob + Alternative product until the transparent suction hose is full of
product and check whether a mixture of water and the Alternative product comes out.
Then turn the knob back in its original position.
6.
Reconnect the hose to output 7 on the mat.
7.
Fill the mat by turning the water knob and “MS HoofClean” (2) to the right and then return
the knob in its original position.
8.
Test it by walking over the mat once and look if the product is present everywhere.
9.
The system now works automatically at the following times.
3 times a day 10 minutes of water + 2.7% main cleaning on Mon, Wed, Fri, Sat
and Sun at 8:00 am, 4:00 pm and 12:00 am
3 times a day 15 minutes of water + alternative product on Tues and Thurs at 8:00
AM, 4:00 PM and 12:00 AM
