Page 30
Copyright © 2022
Standby mode
After the wallbox is properly assembled and installed according to the instructions, it will start into
the standby mode.
In this mode, the
“
Welcome
”
screen is shown on the display and the wallbox is ready for a charge.
If the RFID authentication has been deactivated in the settings, the wallbox will display the following
screen:
Vehicle connected
As soon as authentication takes place and a vehicle is connected to the wallbox, the display changes.
The charging process can now be started if this has not already happened automatically.
If the charging process is started automatically by the vehicle, this display is only shown briefly
before changing to the next display mode. If time-dependent charging is set up by the vehicle, this
screen is visible until the start of the charging, which is controlled by the vehicle.
