LCEN-401P
10
error code on the time/display area. The error code can be checked in the table 11-1, and corrective
actions can be applied accordingly.
4) End the operation
（
1
）
The centrifuge will brake when it reaches the set time or
button is pressed.
⚫
When the rotor stops rotating, the centrifuge will start beeping to alert the operation has finished.
（
2
）
Open the door
⚫
The door can be released automatically when the operation has stopped.
⚫
With the door closed, you are able to press the
button to open it.
⚫
After ending the operation, the program will store the setting parameters of this operation, and will
recall these parameters when restarting the program.
（
3
）
Open the door and take out the rotor and samples.
9.1.2
Customized program operation
Press the
button to select P program. There are 9 programs (P1-P9) available and 6 steps for each
program.
1
）
P1-P9 programs
（
1
）
Press the
button to select P1 program. When P1 icon flash, press parameter knob
to
confirm P1 program. Rotate the parameter knob
to set the speed value and press to set time
value. Press step button
to enter second step parameters setting. There are maximum 6
steps available for setting.
（
2
）
Press button
to start running.
（
3
）
Warning display
⚫
If an error occurs during the operation, the centrifuge will brake to stop automatically, and display the
error code on the time/display area. The error code can be checked in the table 11-1, and corrective
actions can be applied accordingly.
2
）
End the operation
（
1
）
The centrifuge will brake when it reaches the set time or
button is pressed.
⚫
When the rotor stops rotating, the centrifuge will start beeping to alert the operation has finished.
（
2
）
Open the door
