MRC DRS4000, User And Technical Manual

Page: 61 / 88

Troubleshooting 3-5 DRS4000 Receiver User and Technical Manual
3.4 General System Problems
The following table describes general system problems.
Table 3-3: General System Problems
Problem Possible Cause Suggested Actions
Cannot connect to the DRS4000 web server. Receiver is powered down or disconnected
from the network. Verify that the receiver is powered up and that
it is connected to the network.
Receiver IP address is incorrect. From the control screen, select Setup, select
IP and MAC Address Configuration , and
enter the correct IP address.
Receiver does not power up. Power cable not connected. Verify that the power cable is fully connected at
both ends.
Fuse is blown. 1. Set the power switch to off and
remove the power cable from the
receiver.
2. Remove the fuse holder from the
connector block and inspect the
fuses.
3. Replace fuse(s), if required.
4. Reinstall the fuse holder and power
cable.
5. Set the power switch to on.