MRC DRS4000, User And Technical Manual

Page: 54 / 88

Routine Operation 2-38 DRS4000 Receiver User and Technical Manual
4. Select encryption mode required, enter the encryption
key(s), as required, and select the corresponding
Change option button(s).
2.13.8 Review Hardware/Software Configurations
The procedure required to review diversity receiver, MPEG
decoder, processor board, and packet switch serial numbers and
software revisions is contained in the following steps.
1. Verify the DRS4000 is connected to the remote PC
per
“Connect to the Web Browser” on page 2-34 .
2. Select the System Configuration tab.
3. Select the Hardware Info tab. See Figure 2-54 .
Figure 2-54: System Configuration Hardware Info Tab -
Typical
4. Review data, as required.
2.13.9 Rename/Select Site Management
The procedure required to set site management On or Off is
contained in the following steps.
1. Verify the DRS4000 is connected to the remote PC
per
“Connect to the Web Browser” on page 2-34 .
2. Select the System Configuration tab.
3. Select the Site Management tab. See Figure 2-55 .
Figure 2-55: System Configuration Hardware Info Tab -
Typical