2
Linear Steam Head
®
®
Installation Section – Read Me First & Cautions
Model 104480
• Steambath controls feature an integral temperature
sensor. Locate the Steam Head in a location where steam
emissions will not come in direct contact with the control
(or the remote temperature sensor). Failure to follow
these instructions may result in a hazardous condition,
scalding or personal injury.
• Use the supplied high temperature silicone sealant as
required to create a permanent moisture seal. Do not seal
the steam head with grout or any other material. Failure
to follow these instructions may result in property
damage.
• The Linear Steam Head model 104480 must be installed
by a qualified and licensed plumber. Failure to use a
qualified and licensed plumber may result in a leak within
the wall cavity and cause problems associated with leaks,
moisture and property damage from leaks.
• DO NOT use black iron pipe or galvanized pipe for the
steam line. Use brass pipe or copper tubing only, and in
accordance with national and local plumbing codes. Using
any piping material other than brass or copper may cause
problems associated with leaks, moisture and property
damage from water or steam leaks.
• Do not modify or alter the steam head. Do not cover,
block or insert any product that is not a MrSteam supplied
product into the steam outlet. Failure to follow these
instructions may result in a leak within the wall cavity, or
result in a hazardous condition and/or personal injury.
• See the Installation and Operation Manual provided with
the steam generator for additional important installation
and operation information. If this installation and
operation manual is not available then go to
www.mrsteam.com for an online copy, or contact
MrSteam Customer or Technical Services at 800-767-8326
or 800-727-8326 for a free copy.
• Do not disassemble the steam head. The steam head is
shipped fully assembled and requires no additional
assembly. Failure to follow these instructions may result in
a leak within the wall cavity and cause problems
associated with leaks, moisture and property damage
from leaks.
• Consult with manufacturer of acrylic, fiberglass and other
non-heat resistant enclosures for elevated temperatures,
steam, and moisture compatibility. Consult with supplier
of acrylic, fiberglass and other non-heat resistant
enclosures for suitability for use with steam.
• To prevent damage to property do not locate the steam
head where steam, elevated temperatures, moisture or
water can contact any products, wall surfaces, materials,
door seals, devices, electronics that are not designed for
steam, elevated temperatures, moisture or water.
• Do not use abrasive cleansers or chemicals to clean the
steam head. Use only water with mild soap and a non-
abrasive sponge. The use of abrasive cleansers or
chemicals will damage the finish on the Linear Steam Head.