CA4HC WALK-BEHIND TROWEL • OPERATION MANUAL — REV. #1 (06/24/20) — PAGE 23
Blade Pitch Cable Installation
1. For trowels equipped with a
standard
handle, turn the
star wheel counterclockwise to release tension on the
blade pitch cable. See Figure 10.
Figure 10. Blade Pitch Cable Adjustment
(Standard Handle)
2. For trowels equipped with a
Quick Pitch™
handle,
squeeze the trigger lock and push the trigger towards
the engine to release tension on the blade pitch cable.
Figure 11. Blade Pitch Cable Adjustment
(Quick Pitch™ Handle)
INCREASE
BLADE PITCH
(CW)
DECREASE
BLADE PITCH
(CCW)
CAUTION
The Quick Pitch™ trigger is under spring tension and
can snap in the direction of force (toward the user) if
not firmly grasped, which may cause bodily injury.
TRIGGER
LOCK
TRIGGER
3. Remove any nuts from the pitch cable end. Insert the
cable through the yoke eyelet (Figure 12).
Figure 12. Cable to Yoke Attachment
4. Thread the conical nut (Figure 12) up to the eyelet.
Tighten the conical nut by hand to remove all of the
slack from the cable.
5. Thread the locking nut (Figure 12) up to the conical
nut. Use a wrench to tighten the conical nut against the
yoke boss. This will lock the cable in place.
6. Use a wrench to tighten the locking nut (Figure 12)
against the yoke boss.
YOKE
EYELET
PITCH
CABLE
CONICAL
NUT
LOCKING
NUT
YOKE
SETUP
To
order
go
to
Discount-Equipment.com
