CA4HC WALK-BEHIND TROWEL • OPERATION MANUAL — REV. #1 (06/24/20) — PAGE 21
SETUP
ASSEMBLY AND INSTALLATION
Some components must be installed before the trowel can
be operated. This section provides general instructions
on how to install these components.
For detailed handle
assembly intructions, contact Multiquip and request
Instruction Sheet P/N 21766 (standard handle) or
P/N 21849 (Quick Pitch™ handle).
Handle Tube Installation
Attach the main handle (tube) to the gearbox using the
supplied hardware as shown in Figure 5.
Figure 5. Handle Tube Installation
Quick Pitch™ Handle Assembly
If your trowel is equipped with a folding Quick Pitch™
handle, you will need to unfold and adjust the handle to
the upright position prior to operation. It was assembled
at the factory and shipped in its folded or stowed position.
MAIN HANDLE
TUBE
NYLOC
HEX NUT
HEX
SCREW
GEARBOX
CAUTION
The Quick Pitch™ handle is spring-loaded. Personal
injury or damage can result from improper handling,
installation, or adjustment.
Use extreme caution
when
handling this component.
1. Make sure that the Quick Pitch™ trigger (Figure 6) has
been attached to the upper handlebar and the pitch
control cable has slack.
Figure 6. Quick Pitch™ Handle Assembly
2. Rotate the T-handle knob (Figure 6) on the top side of
the upper handlebar counterclockwise to remove the
knob from the swing bolt.
3. Move the Quick Pitch™ handle toward the operator’s
position and unfold the upper handlebar away from the
engine into the upright position (Figure 6).
4. Reinsert the swing bolt through the slot in the hinge
plate (Figure 6). Turn the T-handle knob clockwise to
secure the upper handlebar in place.
TRIGGER
TRIGGER
LOCK
UPPER
HANDLEBAR
HINGE PLATE
T-HANDLE KNOB/
SWING BOLT
OPERATIONAL
(UPRIGHT)
POSITION
STOWED
(FOLDED)
POSITION
NOTICE
When folding the Quick Pitch™ handle assembly,
remember to first move the Quick Pitch™ trigger
forward to avoid stretching the throttle cable.
To
order
go
to
Discount-Equipment.com
