For VIBRO-COMPACTOR MODEL MVR-R60
Reassembling the governor lever assembly:
The governor lever assembly should be totally disassembled except for hollow setscrew (62) and nut M8
(63) (See Fig.A).
<Note 1>
(Fig.-A)
Disassembling the Governor Lever Assembly:
Disassembled hollow setscrew (62) and thin nut M8 (63)
should be reassembled to be flush with each other as shown
in Photo B and C.
Parts not to disassemble.
Caution! channel
Photo D
20mm
Photo E
Photo B:
Properly done.
Photo C:
Correction required.
Reassembling Procedure:
1. Insert the slider (53) into throttle body (51) with its groove coming in the
back. (Photo D)
2. Install the outer governor wire (64). (Photo E)
(In case the end of inner governor wire should be bent, install inner and
outer wires together by taking measures of steps 3 and 4 below to get the
result as shown in Photo H.)
3. Insert inner part of governor wire (64) through throttle body (51)
(Photo F and G)
4. While pulling the end on inner wire which has come out of outer
part of governor wire, rotate it so that the gear teeth of slider is
visible. (Photo H).
Apply grease.
Teeth should come to surface
.
Photo H
Place head in groove.
Photo G
Insert inner part
Photo F
5
Summary of Contents for Mikasa MVH120
Page 13: ...10 ...
