MPM iCoook MRK-18, User Manual, Page: 32 / 78

34
EN
PREPARATION FOR USE
1. Unpack the appliance from the cardboard, remove all bags, labels, cardboard and fillers. Check the
appliance for any damage that may have occurred during transport. In case of any doubts, please
contact the seller.
2. Make sure that the parameters of your mains supply correspond to the technical data on the
product rating plate.
3. Thoroughly wash and dry all parts in contact with food following the instructions in the section
“CLEANING AND MAINTENANCE”.
4. Place the appliance on a dry, flat, stable and horizontal surface.
5. The appliance has a safety system - it can only be switched on if the jig (8) and the jig lid (2) are
correctly fitted.
FITTING/REMOVING THE BOWL
ATTENTION! Never run an incompletely assembled appliance. Risk of injury!
1. Check that the seal is correctly fitted on the drive shaft (25).
2. Insert the drive shaft (25) into the bowl so that the sprocket goes through the hole in the bottom
of the bowl and then lock the drive shaft by applying the lock (26) on it from the outside and
turning it slightly clockwise (Fig.1)
3. Place the bowl (8) on the housing of the appliance (11) so that the capacity marks inside the bowl
face the rear of the housing (Fig. 2).
4. Put one of the accessories on the installed shaft (25) (Fig.3):
-
lightweight pulp- butterfly mixer (4)
-
mixer (5)
-
knife (6)
-
strainer (7).
ATTENTION! The knife blades are sharp. Be careful not to get hurt!
5. Make sure that the seal (3) is properly seated in the bowl lid (2). It must be properly seated in the
groove for the seal around the entire circumference.
6. Place the bowl lid (2) on the bowl (8) as shown in Fig. 4, press it down and turn it so that the
handles of the bowl and the lid overlap (the tabs in the lid will take their places in the sockets of
the bowl).
7. To remove the bowl from the appliance, follow these steps:
-
turn the lid (2) slightly counterclockwise so that the tabs in the lid slide out of the sockets in
the bowl, carefully remove the lid
-
remove the bowl from the base of the food processor
-
remove the accessory (butterfly, mixer, knife) from the rotary shaft
-
remove the strainer using the strainer holder in the bottom of the measuring cup (Fig.5).
FITTING/REMOVING THE STEAMER CONTAINER
1. Follow the steps described in point 1-3 in the section FITTING/REMOVING THE BOWL.
2. Make sure that the seal (24) is properly seated in the steamer container (23). It must evenly adhere
around its entire circumference to the outside of the ring in the container.
3. Place the steamer container (23) on the bowl (8) as shown in Fig. 6, and turn it so that the handles
of the bowl and the lid overlap (the tabs in the lid will take their places in the sockets of the bowl).
Place the tray (22) on the container (23) and cover the lid (21).
4. To remove the steamer container from the appliance, follow these steps:
-
remove the lid (21) and the tray (22)