Chevrolet Impala 2004 – 2005
1. Connect the universal VSS cable to the radar’s power/signal cable.
2. Route the blunt cut end of the universal VSS cable through the firewall into the driver’s side engine
compartment.
3. Locate the VSS wire (dark green) at Pin K of the Cruise control connector at the driver’s side wheel well area
.
Note: there are two dark green wires, only pin K is the VSS signal.
4. Using a scotch-lock t-tap and male quick-slide terminal, connect the red wire of the VSS cable to the vehicle
VSS wire.
5. Connect the black wire of the VSS cable to a vehicle chassis ground.
6. Secure all cables and proceed to accuracy test.
Chevrolet Impala 2007 and newer
1. Connect the universal VSS cable to the radar’s power/signal cable.
2. Locate the 22 gauge Brown wire (VSS) in the blunt cut ignition controlled voltage and signal wires that are part
of a 5 foot wire loop located under the instrument panel in the passenger foot well.
Note: The other wires in
this harness are yellow, pink and yellow/black.
3. Connect the red wire of the universal VSS cable to the vehicle’s brown VSS wire.
4. Connect the black wire of the VSS cable to a vehicle chassis ground.
5. Secure all cables and proceed to accuracy test.
Ford Mustang 2000 – 2004
1. Connect the universal VSS cable to the radar’s power/signal cable.
2. Route the blunt cut end of the universal VSS cable through the firewall into the passenger’s side engine
compartment.
Dark Green w/ whit tracer Pin 15
C108 – 2000 Mustang
C139 – 2001 to 2004 Mustang
31
