12
®
www.mpbio.com
3.2
PREPARING THE FastPrep 24 FOR OPERATION
1. Turn the main Rocker Switch ON (
®
2. Factory-set default values automatically program FastPrep -24 to operate at
speed 4.0 m/sec, Tube holder MP:24*2 and run time 20 seconds (to override
these values. See programming)
This symbolizes
On and
Off supply
3.3
PROGRAMMING THE FastPrep 24
Make sure Emergency Switch is pulled out).
User can take default setting or his own. Five different combination of setting can
be saved as described in next section.
can be changed at this moment. Press
p
or
q
key to change the default Speed to User Selectable Speed. Once speed is selected,
press SET again, flashing of 4.0M/S will stop to indicate that speed has been
selected.
Switch ON Power Supply using Rocker Switch Provided at the Back, Make sure
Emergency Switch is pulled out.
On Power ON the LCD will Show
WELCOME
followed by
MP Bio
Press SET key to start programming
Once SET key is pressed, LCD will show
4.0 M/S
which means it's the default
Speed, If Option 1 is needed than press SET key again, the
4.0 M/S
message on
LCD will start flashing to indicate that it
-
®
-
