Moxa MxNVR Industrial Video Recorder
Getting Started
3-3
ATTENTION
A ground loop isolator is recommended to be used between the camera and the MxNVR-MO4 to avoid a sudden
current that burns out the VPort’s chips and boards, generated by the electric potential difference between
these two device’s ground power.
Step 4: Install the 2.5” HDD (hard disk) or SSD (solid state disk)
The MxNVR-MO4 has a HDD tray located in the bottom. There are few steps to install the HDD or SSD.
NOTE
It is recommended to remove the power input before installing the hard disk.
1.
Loosen the 2 thumbscrews and use them to pull out the HDD tray.
2.
Remove the protective membrane of the thermal pad located on the top of the HDD tray.
3.
Install the 4 yellow anti-vibration pads into the 4 HDD screw brackets, and loosen the 2 screws of the SATA
connector holder
4.
Connect the 2.5-inch HDD or SSD with the SATA socket, and then screw the 4 HDD screws on it with the
HDD tray.