- 6 -
Wall Mounting (Optional)
For some applications, it may be more convenient to mount the
AWK-1137C to a wall, as illustrated below:
STEP 1:
Remove the aluminum
DIN-rail attachment
plate from the
AWK-1137C, and then
attach the
wall-mounting plates
with M3 screws, as
shown in the adjacent
diagrams.
STEP 2:
Mounting the AWK-1137C to a wall requires two
screws. Use the AWK-1137C device, with
wall-mounting plates attached, as a guide to mark the
correct locations of the two screws. The heads of the
screws should be less than 6.0 mm in diameter, and
the shafts should be less than 3.5 mm in diameter, as
shown in the figure on the right.
Do not drive the screws in all the way—leave a space of about 2 mm to
allow room for sliding the wall-mounting panel between the wall and the
screws.
NOTE
Test the screw head and shank size by inserting the screws into
one of the keyhole-shaped apertures of the wall-mounting plates
before they are fixed to the wall.
STEP 3a:
Once the screws are fixed into the wall,
insert the two screw heads through the
large opening of the keyhole-shaped
apertures, and then slide the
AWK-1137C downwards, as indicated
to the right. Tighten the two screws for
added stability.
STEP 3b:
Alternatively, insert four screws
directly through the AWK-1137C into
the wall.
