Movincool Classic Plus 14, Service Manual

Page: 10 / 46

CONSTRUCTION, SPECIFICATIONS & DATA
5
1. Basic Construction
The MovinCool Spot Cooling System is
compact in construction because the con-
denser and the evaporator are enclosed in
one unit. The interior is divided into three
sections. The upper front face is equipped
with the evaporator, while the lower front face
contains the drain tank. The rear section
contains the condenser, the compressor and
the control box.
2. Air Flow
Air drawn from the right side face passes
through the condenser which extracts the
heat. This hot air is blown out through the
upper exhaust air duct. Air taken in from the
front face is cooled by the evaporator and
then blown through the cool air duct which
can be turned in any direction. All the air
inlets are equipped with filters, while the
exhaust air duct is protected by wire mesh.
3. Compressor and Fans
The compressor is hermetically sealed. A
two-speed fan motor is used with two cen-
trifugal fans to draw air across the evaporator
and condenser.
4. Drain Tank
The capacity of the drain tank is 5.0 gallons
(19 liters). The unit is equipped with a "Tank
Full" LED and a device to automatically stop
the operation of the unit when the drain tank
reaches a level of approximately 4.0 gallons
(15 liters).
Air Flow