178
04/2007
MOVIECAM COMPACT Mk2
9 – THE MOVIECAM POWER SUPPLY
179
04/2007
MOVIECAM COMPACT Mk2
9 – THE MOVIECAM POWER SUPPLY
CHAPTER 9
THE MOVIECAM POWER SUPPLY
THE MOVIECAM POWER SUPPLY UNIT
All Power Supply Units supplied for MOVIECAM came-
ras can be used with the COMPACT Mk2 camera.
[a]
Main switch
[b]
Camera supply 24 V/8 A stabilized
[c]
Charge start button
[d]
Charger control LED
[e]
Plug socket
110 V or 220 V
[f]
Battery charger 24 V/1.3 A
[g]
Connector
110/220 V – 50/60 Hz
[h]
Fuse
Rear side
1 x 2 A glass fuse
Front side
8 A automatic fuse
2 A automatic fuse
2 A automatic fuse
2 A automatic fuse
The BAT LED
[d]
lights up in case the voltage drops
below 20.5 V.
The integrated, thermostatically controlled heating ele-
ments of the camera need approx. 20 W, even when
the camera is not running.
The Mk2 has a newly designed temperature sensor
– the camera heater is processor controlled; it switches
on at 5° C and it switches off at 10° C.
The MK2 camera can be powered either by a MOVIE-
CAM Power Supply Unit or a MOVIECAM Battery
Block.
A stabilized 24 V (direct current) outlet, a 110 V/220
V (alternating current) outlet and a lead battery charger
are integrated in the Power Supply Unit.
Caution!
Prior to connecting the Power Supply Unit with the
mains, check the given voltage and, if necessary,
adjust the selector at the Power Supply Unit rear
accordingly!
When the camera is connected, you can simultaneously
run the camera and charge a Battery Block. You have
to switch on the main button
[a]
of the Power Supply
Unit not only to operate the camera (switch lights red),
but also when the Power Supply Unit serves as battery
charger.
Charging needs approx. 4 – 6 hours and is indicated
by a green diode
[d]
lighting up. It fades out when the
battery is fully charged. Start charging by pressing the
small button charge
[c]
.
THE POWER SUPPLY
fig.9/1
[c]
[d]
[e]
[f]
[a]
[g]
[b]
[h]
