37
EN
• Make sure that the appliance is complete and
correctly assembled.
• Position the chipper on levelled and solid ground
before use (risk of overturning).
• Use the appliance only in the external environment. A
minimum safe distance from other walls (outdoor) or
other solid obstacles is 2 m.
• Check before each use:
− the power supply cable for any defective points
(cracks, cuts, etc.);
do not use defective cables
− the apparatus for damage (see the section Safety
of work)
− whether all screws are tightened properly
Connection to the mains
• Compare voltage on the type label with the value of the
mains and connect the appliance to the corresponding
and approved socket.
• Connect the unit using correct fuses.
• Use an extension cable of a sufficient cross section.
Mains fuses
2 600 W / 2 800 W
16 A slow
Mains impedance
In the case of unfavourable conditions in the mains, a
short drop of voltage may occur at appliance turning
on which may affect other appliances (such as light
dimming). If the maximum mains impedance specified in
the table is complied with, no defects are expected.
Power input P
1
(W)
Mains impedance Z
max
(
Ω
)
2 600 W / 2 800 W
0,31
Switch/circuit breaker
Do not use any devices which are not provided
with a switch with possibility of switching on/off.
Damaged switches should be submitted for repair
or replacement in a service plant.
Commissioning
ON
Reset button
(motor protection)
Reverse
operation
OFF
Forward operation
Rotation
direction
switch
Turning on
Depress the green button I
Turning off
Depress the red button 0
Protection against restarting
in the case of power failure
The appliance is turned off automatically in the case of
the power supply failure (zero voltage switch). To restart
the appliance, it is necessary to depress the green
button again.
Motor protection
The motor is provided with a circuit breaker which is tripped
automatically in the case of overload. The motor can be re-
started after a cooling down phase (approximately 5 minutes).
Depress
1. The reset button (motor protection)
2. The green button I for restarting.
Rotation direction switch
Use the rotation direction switch only if the chipper is
turned off.
Forward operation – position
Material is pulled in and chipped with a cylindrical
cutter.
Reverse operation – position
The cutter is revolving in the opposite direction and blocked
material is released. After you change the rotation direction
switch to the position , hold the green button of the switch/
circuit breaker depressed. Cutter revolving is switched over to
the opposite direction. If you release the switch/circuit breaker,
the chipper stops automatically.
Tips
• Large objects and pieces of wood are removed after
repeated turning on in both the direction of chipping
and the direction of releasing.
• Use a wooden rod or hook for the removal of blocked
objects from the hopper or ejection opening.
Before you start the chipper again, wait until
the machine is stopped.
Collection basket
The incorporated collection basket is fitted with
a locking device with unit safety turning off.
Turn the machine always off before the installation
or removal of the collection basket.
➱
The collection basket is closed and firmly
connected with the unit.
➱
The collection basket is unlocked and can
be removed from the unit. The unit cannot be
started in this case.
If you release the lock of the collection basket during
operation, the unit is stopped automatically.
