Mountfield 4140H, Instructions For Use Manual, Page: 14 / 86

14
ENGLISH
EN
The quick connections allow the deck to be moved
easily between the two positions:
• Normal position with fully tensioned belt.
• 4 cm behind the normal position with slackened
belt so that the deck gets closer to the base
machine.
As the belt idler is released from the belt, the quick
connections simplify belt and deck replacement,
and also make shifting to the washing position and
service positions easier.
Releasing the belt tension:
1. Remove the locking pins (12:G) from both
sides.
2. Open the quick connections by depressing their
rear sections with your heel. See (12:F).
When the quick connections are
opened, the deck arms rest loosely in
the shaft sections. The deck must never
be set to the service position or washing
position without relocking the quick
connections after unhooking the deck
belt.
3. Carry out the necessary corrective action, e.g.:
• Unhook the belt.
• Replace the deck by unhooking the deck
arms. See fig. 14.
Tensioning the belt:
First tension one side and then the other according
to the instructions below.
Do not turn the lever using your hands.
Risk of crushing injuries.
1. Place your foot on the lever (13:J) and carefully
turn a half turn forwards.
2. Install the locking pin (12:G).
3. Carry out the above on the other side.
5 AREAS OF USE
The machine may only be used using genuine
GGP accessories, e.g.:.
The maximum vertical load on the towing hitch
must not exceed 100 N.
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.
Operation Accessories, GGP original
Mowing Using mowing decks:
4140H: 95 C
4155H: 95 C, 105 C
4155H 4WD: 95 C, 105 C
Snow clearance With snow blade. Snow chains
and frame weights
recommended.
Grass clipping and
leaf collection With towed collector 38".
Grass and leaf
transport With dump cart Combi.