Motus M990T, Service Manual

Page: 38 / 105

37
2.13 How to Replace the Contact Heart Rate Sensor
Do the steps below while referring to the following Exploded Views in Appendix.
E.1 CONSOLE ASSEMBLY
1) Turn off the unit power at the switch and then unplug the line cord at wall outlet.
2) Remove four screws (B25) and two screws (B21) securing SIDE HANDLE TOP/BOTTOM
(C6, C7, C8 & C9) and then remove SIDE HANDLE TOP/BOTTOM from the Console Assembly..
3) Remove six screws (B27) securing the FRONT HANDLE TOP and FRONT HANDLE
BOTTOM to the HANDLE CROSS PIPE (C10) and then remove the FRONT HANDLE
TOP/BOTTOM from the Console
Assembly.
4) Disconnect the sensing wire
from the inside TERMINAL of
the SENSOR PLATE which is
located on the FRONT HANDLE
TOP.
Note: The FRONT HANDLE
TOP has four SENSOR PLATEs
and each SENSOR PLATE has
one TERMINAL.
5) Remove the SENSOR PLATE from the FRONT
HANDLE TOP by straightening the bent fixing tips
indicated as A.
6) Install new sensor in reverse order while bending
four fixing tips.
7) Repeat the above steps for the remaining SENSOR
PLATE 4) through 6).