Motus M990T, Service Manual

Page: 16 / 105

15
1.5 Lubrication Guide
Basically, initial lubrication is performed at factory, but the oil could be dried during transportation or stock in your warehouse.
As soon as you complete installing, please lubricate and then make sure that oil is enough or not as below.
1) Turn off treadmill
.
2) Push the striding belt backward using your feet while holding the front handle bar or side handle bar.
3) You can judge whether the friction is enough or not by feeling the smooth move of the belt. Lubrication is needed if the belt is not pushed well.
z Lubricant prevents the belt and deck from being damaged by frictional heat, which extends life span of the deck and belt.
z Use the lubricant provided by Motus only.
KF54
silicone fluid made from
Shin-Etsu Chemical Co. Ltd.
How to manage automatic lubrication system (M990T, M990TL)
A certain amount of oil is lubricated automatically every lubrication interval which is preset at Manager Mode. Default lubrication amount and
lubrication interval are set up to, for instance, 30cc and 500km, respectively, which can be set at Manager Mode. Therefore, it is recommended that
fitness club manger set up the lubrication amount and interval according to club condition.
A volume of lubricant tank is about 270cc, and if residual amount of oil is less than 20%, the warning SYMBOL is displayed on the screen with a
beep. At that time, fill the tank as instructions below.
1) Turn OFF the treadmill and open motor hood.
2) Open the cap of oil tank by turning it with hand.
3) Fill the empty tank fully with the oil provided by Motus. Keep in mind that automatic lubrication system doesn’t work properly if oil is not filled full.
4) Close the cap of oil tank and put the motor hood in place.
5) Turn ON the treadmill. Message indicating oil lack will be still displayed on the screen with the beep.
6) To input “finishing oil-filling”, press buttons in the order as below.